Toe Kick Return

Our solid, square products are made with our precision dowel process using Canadian-made, high-quality materials.



Set Project Options

Unit conversion

Input length in inches for its value in millimeters.
To convert from inches (in) to millimeters (mm), simply use the following formula:
millimeters = inches × 25.4

This is because one inch is equivalent to 25.4 millimeters. Therefore, by multiplying the number of inches by 25.4, you can determine its corresponding length in millimeters.
SKU: 2838023a778d-1 Category:


This is used when there is no panel on an the end of a run of base or tall cabinets. Usually beside dishwashers or stoves, where a panel isn’t required to cover the colour of the cabinet box (as the appliance will cover the box colour).
Toe kick returns have one short end edge banded, as it is exposed to the front of the cabinet. This piece runs from the front of the toe kick, down the side of the cabinet legs to the wall.
The cabinet you are to use this on will need Finished End Legs on the side this is going to go. Please ensure the toe kick return is deep enough incase you need to scribe it to fit to the wall. As toe kicks are recessed from the front for the cabinets, ordering the return at the cabinet depth should be adequate with room to cut it perfectly to the wall.
This toe kick will come in the Exterior Colour selected in the Project Dashboard.
If the Exterior Colour selected has grain direction (is not a solid colour), then the grain will run with the Depth.

For a preview of our high-quality, Canadian-made materials, click here.